Nominal diameter: Pipeline PTFE lining: DN10~DN600 (mm)
Pipeline rubber lining: DN40~DN2000
Range ratio: 50:1
Accuracy level: 0.5 level
Temperature of the tested medium: ordinary rubber lining: -20 to+60 ℃
High temperature rubber lining: -20 to+90 ℃
PTFE lining: -30 to+120 ℃
High temperature PTFE lining: -20 to+160 ℃
Rated working pressure: DN10~DN50 ≤ 4MPa
DN65~DN200≤1.6MPa
DN250~DN1000≤1.0MPa
DN1200~DN2000≤0.6MPa
Conductivity range: The conductivity of the measured fluid is ≥ 5 μ s/cm
Signal output: 4-20mA, pulse/frequency,
Communication output: RS485, MODBUS protocol, HART protocol
Power supply: AC220V or DC24V
WEF electromagnetic flowmeter is widely used to measure the volumetric flow rate of conductive liquid and liquid-solid two-phase fluids. The measurement results are independent of the temperature, viscosity, density, pressure, and liquid-solid composition ratio of the fluid, and the conductivity changes over a large range without affecting the measurement results. Therefore, after being calibrated with ordinary water, it can be used to measure the flow rate of other conductive liquid-solid two-phase fluid media without any additional correction. The WEF electromagnetic flowmeter consists of an electromagnetic flow sensor and an electromagnetic flow converter, which can be assembled together to form an integrated structure or installed separately to form a separate structure. The installation of the integrated structure makes wiring very simple.
Typical applications
Widely used in industrial sectors such as petroleum, chemical, metallurgical, textile, papermaking, environmental protection, food, as well as municipal management, water conservancy construction, river dredging and other fields for flow measurement.

Copy product links
Long by picture save/share
